Chassis and drive mount

This is the start of the chassis. It is composed of 30mm by 30mm by 3mm by 1m angle bracket.

The longer side is 300mm long and the shorter side is 100mm long. As you can see, my chassis is imperfect but it will have to do for now.

This is an example of the drive train mount. Its it the exact same to the mounting brackets for the servos but the placing of the holes for attaching it to the chassis can vary. As you can see my holes for attaching it to the chassis is in the middle, If you are choosing that the drive mounts should be down low like mine(in case you build my design) don't make the holes in the middle but up high as possible unless you modify the configurations.

This is what the drive train and suspension setup should look like in the early stages, 2 down 4 to go.